KABO GROUPSafety engineeringWe select a fire protection build-up for ductwork according to the design, network configuration and actual access to installation areas.
We select a fire protection build-up for ductwork according to the design, network configuration and actual access to installation areas.
KABO GROUP reviews the available information, prepares an agreed technical scope and completes the work with the defined documentation.
Inputs, system interfaces and completion evidence are agreed before work begins.
Open section↗Inputs, system interfaces and completion evidence are agreed before work begins.
Open section↗Inputs, system interfaces and completion evidence are agreed before work begins.
Open section↗Inputs, system interfaces and completion evidence are agreed before work begins.
Open section↗We assess the building use, protected area, fire risks, existing engineering services and the required performance before agreeing the technical solution.
The estimate reflects system size, equipment or materials, access conditions, interfaces, commissioning and the completion documents agreed for the project.
KABO GROUP can survey, design, supply, install, test and hand over the system, followed by planned maintenance where required.
During application we record material batches, substrate preparation, ambient conditions, consumption and intermediate measurements. Coatings are checked for thickness, continuity and adhesion; boards and penetration seals are checked as complete tested assemblies.
Handover may include work records, concealed-work records, area drawings, inspection protocols, material documentation and maintenance guidance. The exact package is agreed in the contract and design.
Duct fire resistance depends on the complete assembly, not only the material on flat surfaces: sheet metal, flanges, joints, fittings, hangers, fixings, penetrations and protection method all matter.
The design defines fire-resistance class, duct purpose, exposure direction and permitted system configuration. Unverified changes to mat thickness, fixings or joint treatment may invalidate the classified solution.
Dampers, access panels, wall and floor crossings, transitions, branches and hangers are detailed separately. These locations often determine real system quality and must remain accessible for installation and inspection.
Before enclosure, continuity, thickness or layer count, fixing spacing, joint treatment and route compliance are checked and recorded as concealed work and as-built information.
This list explains the regulatory basis but is not a substitute for a project or a complete schedule for every building. Document status, amendments and building-specific requirements are verified when the project starts.
Regulates fireproofing work, conformity checks and continued serviceability of coatings, impregnation, encasement and products.
Open source↗Building regulationSets general fire-safety, fire-resistance, evacuation, compartmentation and engineering requirements.
Open source↗Technical standardsUsed for fire-resistance or reaction-to-fire classification and assessment of the tested system within its field of application.
Open source↗Industry guidanceIndustry guidance on reactive and non-reactive systems, selection criteria, section factors and exposure conditions.
Open source↗Official manufacturer videos demonstrate preparation, installation and material behaviour under flame exposure.
All channel videos ↗A real 20,000+ m² project using several Ammokote systems under client supervision.
Open on YouTube ↗System components and the installation sequence for a fire-resistant cable penetration.
Open on YouTube ↗Videos are provided by the official Ammokote fire-protection materials channel. The project defines the applicable system and coating thickness.
We receive drawings, specifications, fire-resistance requirements and available information about the site.
We verify the actual condition, geometry, access and preparation requirements.
We select a compatible fireproofing system and define the required scope.
We agree materials, quantities, site conditions, responsibilities and timing.
Yes, after reviewing joints, hangers, intersections and actual site access.
We start with the available information, a site survey and an agreed technical brief.
Cost depends on floor area, building configuration, system scope, access conditions and the required completion documents.
The building type, city, approximate area and required system are enough to begin.
